Display What To Do
Press Enter to access the Program Menu.
Use the “+” or “-”button to select a register, and press Enter.
Press the Enter button to read the current value.
Once the Commander reads the current value, press the Exit
button to return to the register selection menu.
Use the “+” button to select register 8.
Press the “+” button again.
If the display changes to c09, you are now in Direct Mode.
If the display returns to r1, your decoder does not support
Direct Mode.
Once the Commander is in Direct Mode, you may access any of the CV's sup-
ported by your decoder (see Decoder manual for further information).
If your decoder does not support Direct Mode programming, you may use
another decoder to pass the Direct mode test, and then switch back to the
decoder you would like to program. While you may not be able to read the
CV's of your decoder, you may still be able to set a new value.
CONSISTING
Consisting your Locomotives
1. Use the “+” or “-” buttons to select the address of the locomotive you
wish to add to a Consist.
2. Press the Forward or Reverse buttons to set the direction that
the locomotive will operate in the Consist.
3. Press the Forward and Reverse buttons at the same time to access
the menu system.
4. Press the “+” or “-” buttons to select the consist menu,
nu,
then follow
the directions below:
Display
What To Do
Press Enter to access the Consist Menu.
Press the “+” or “-” button to select the address you wish to
use to control the Consist.
Press the Enter button to add the selected locomotive to the
Consist, or press Exit to return to the locomotive display. (xx is
the Consist address)
Note: The Consist address can be the address of an actual locomotive or an
unused address.
Add additional locomotives to the consist by repeating steps 1 through 5.
If a locomotive is part of a Consist, the display will indicate this by replacing
the "L" with an "N", or "n". If the display shows "N", the locomotive address
19
20
Comentários a estes Manuais