Controlling Turnouts or other Accessories
Accessory decoders, like your locomotives, require a unique address to allow
independent control. Most accessory decoders are programmed in groups of
four. I.E. (1,2,3,4), (5,6,7,8), (9,10,11,12), ... Accessory decoders must be
programmed like a locomotive decoder (consult the instructions included with
your accessory decoder for programming directions). After the required pro-
gramming you can use the Function buttons on your Commander to control
the turnouts as described below and on the next page.
1. Press both the Forward and Reverse buttons at the same time to
access the Menu system.
2. Press the “+” or “-” buttons to select the Turnout menu, Sch, then
follow the steps below:
Display
What To Do
Press the Enter button to access the Turnout (switch) menu.
Use the “+” or “-” button to select the turnout (or Accessory
decoder) address you desire to control.
(Possible range is 1 through 99)
When you have reached the desired turnout address, Press
F0 or F1 to control the turnout.
The direction the turnout will throw will depend on how it is connected to the
Accessory Decoder. If the turnout direction is reversed, reverse the two control
wires connected to the Accessory Decoder.
Speed Step Assignment
The speed range from a complete stop to maximum speed is divided in steps.
The larger the number of steps, the better the speed control resolution. I.E The
larger the number of speed steps the smoother the control of the locomotive.
The Atlas Commander supports 14,28, and 128 Speed Steps. Speed step set-
tings are assigned for each locomotive, and each locomotive may be different.
Follow the steps below to view or change the speed steps for the locomotive
selected on the display.
Setting Speed Steps*
1. Use the
“+” or “-” button to select the address of the locomotive whose
speed steps you desire to view or change.
2. Press the Forward and Reverse buttons, at the same time to access
the menu system.
3. Press the
“+” or “-” button to select the Speed Step menu, SPE, then
follow the steps below and on the next page:
*The locomotive must be on the main track and stopped (Speed dial fully
CCW) to change the speed steps.
Display
What To Do
Press Enter to access the Speed Step menu.
The display shows the current speed step setting for the
selected locomotive.
13
14
(261 páginas)
(92 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais